В момента ресурсът е наличен само на английски

Extending cables with Heat-shrink tubing. Teacher's Note Pro Preview

This part of the course is challenging for many of the students. 

Необходимо е да се абонирате за FLLCasts.com, за да достъпите това видео

Абонирай се

  • #750
  • 23 Feb 2018

TL. DR.

Extending a single cable could take well about 5-10 minutes when done for the first time. It is a complex sequence of tasks that students must follow. Start with a single cable and validate the complete result with the students. Only then continue to a second cable.

It takes time 

It takes a lot of time to do it the first time. It might take well over 5-10 minutes for the first cable to be extended. Be patient. After the first cable is extended move to the second, the third and extend all the cables of the car. It could take well over an astronomical hour for all the students to extend all the cables. 

Leave them to do it themselves

Make sure the students could do it themselves. The first time it is hard. The second and third is much easier. They should be able to complete the whole set of sequence of steps. This will have a tremendous learning effect on them. They can just give up somewhere in the middle of the sequence. Teach them patience.

Курсове и занятия включващи този Урок

Този Урок е използван в следните курсове и занятия.

Image for Perfect STEM course. Module 1 - Smart Car with Raspberry PI
  • 118
  • 42:47
  • 136
Image for Extending cables with Heat-shrink tubing
  • 3
  • 0
  • 5
  • 3d_rotation 0