Disconnect the cables from RC car electronics and remove the default controller Pro Preview

It is time to do the first destructive thing in the course. Disconnect the cables from the controller. After this step, there is no going back. This is the most important decision you will face. The world depends on you. The future of the universe depends on you. (But if you make a mistake you can always solder the cable back :)) 

To access the full video please subscribe to FLLCasts.com

Subscribe

  • #742
  • 22 Feb 2018

TL. DR.

Disconnect the cables from the controller. Cut them with a knife or with scissors. Remove the controller.

"Disconnecting" the cables

Disconnect the cables from the default controller by cutting them. You can use scissors to cut the cables. Or a knife. You must cut them very close to the controller. On the pictures below you can see the can with default controller removed, the cables disconnected and the controller without cables on the right picture.

Courses and lessons with this Tutorial

This Tutorial is used in the following courses and lessons

Image for Perfect STEM course. Module 1 - Smart Car with Raspberry PI
  • 118
  • 42:47
  • 136
Image for Disconnecting cables from the controller
  • 2
  • 0
  • 5
  • 3d_rotation 0