Building Instructions

This is the chassis for the popular FTC Push Bot. The robot is built with the Tetrix set and uses two motors. When preparing for a FIRST Technical Challenge competition (FTC) it is very useful to have a chassis from which you could start working. It might not, and will surely not be the final robot, but a good base is always useful. 

With this chassis, we've also made a short course of how to control it. Take a look at FIRST Technical Challenge. Basic GamePads, control and attachments for the Tetrix set.

Simple VEX IQ competition base with a lot of space for attachments and gravity center in the backside of the robot.

A very simple base of the robot that could be used for adding attachments.

Background

Soon after a launch, rocket engines often separate away from spacecraft by design, but that’s long before the spacecraft leaves the pull of gravity. So why doesn’t the spacecraft fall back to earth?

Mission

The robot needs to impact the strike pad hard enough to keep the spacecraft from dropping back down.

Scores

• Get the spacecraft to go so fast and high that it stays up, by pressing/hitting the strike pad: 24
• Possible scores: 0, 24

Scoring Requirements

• The result must be visible at the end of the match.
• Activate the spacecraft by pressing/hitting the strike pad. > Only allowed method. Must be observed by the referee.

(mission descriptions source https://www.first-lego-league.org/)

These are 3D Building Instructions for the Augmented Reality Statue mission model for the FIRST LEGO League 2023-2024 MASTERPIECE competition.

These are 3D Building Instructions for the Light Show mission model for the FIRST LEGO League 2023-2024 MASTERPIECE competition.

These are instructions on how to build the:

• Tree

for the FIRST LEGO League 2019-2020 City Shaper Challenge.

You can find more building instructions and tips and tricks about the competition on this page.

Building instruction for the power switch mission model. The model is used in the Power supply mission of FLLCasts Off-season Challenge 2019.

 

This is a Material supplementing the Instructors training course. Attached is our methodology for working with students. If you spend some time to read it beforehand, we can discuss only the questions that you have, instead of listening to the whole thing. That will be a more efficient usage of our time in the training. 

This is a disk image containing a Raspbian OS. The image is modified and set up specifically for the Perfect course. It contains all the needed files, libraries and additional tools that we would use in the course. The file is quite large so be prepared to wait some time while downloading.

Checksum: 4d85292f49a9350fcef9f2eb8fd86b77f1c6bd65ce1344848de3e201c9e1d20d

These are 3D Building Instructions for M05 Shark mission model for the FIRST LEGO League 2024-2025 SUBMERGED competition. You can also check out the alternative mission model for Shark for additional building possibilities.

This attachment is accomplishing three missions and partly two more missions from the FIRST LEGO League 2022-2023. It is for the Chain Monster robot

We use this attachment to demonstrate the principle of an active attachment. This is an attachment activated from the motor. It has one level attached to it. It could be reused. The attachment transfers power from the motor to the end of the lever and we can accomplish missions like the Power Switch mission from the FLLCasts Off-season mission models.