Building Instructions

During a competition a team of students had to build a robot that looks like a musician. This construction in front of the robot is a Trompet and it looks like Ane is playing some music. If you play music on the phone on the side it is really funny to watch it play.

This is the Coffee Pot, along with a coffee mug. It was 2 hours of fun

You know those constructions that you need to push or pull something and you get a cool chain reaction, right? Here are the building instructions of such a Chain Reaction built with LEGO Mindstorms 51515 Robot Inventor set. This construction was created to be used with the smallest Inventor robot Tricky and its Kick the ball attachment. The goal is to program the robot to kick the Mindstorms/Duplo ball, included in the set, so that the ball could push the lever and start the chain reaction.

You can find the LEGO set, with which this was built, by following this link.

You can find constructions created to play with Tricky, by following the links below:

1. Bowling Pins
2. Football Goal
3. Basketball hoop

This robot is named after the South Pole–Aitken Basin, the largest impact crater in the Solar System, located on the far side of the Moon.

Astronauts, get ready to enter lunar orbit! This robot is equipped with a holder for a camera or phone, allowing it to take a picture of the far side of the Moon. If your device does not fit, you can easily adjust the holder to suit your needs.

With its two motors, Aitken can move in both wide and narrow circles around the Moon to capture the perfect photo.

These are instructions on how to build the:

• Colored health units
• Season tiles

You can find more building instructions and tips and tricks about the competition on this page.

These are instructions on how to build the:

• Heavy Tire Flip

You can find more building instructions and tips and tricks about the competition on this page.

These are instructions on how to build the:

• Light Tire Flip

You can find more building instructions and tips and tricks about the competition on this page.

This was an idea. You would we demonstration a multi-axle power and rotation transmitting box. Well, here it is. Build it. Start it. And see how the power from the motor is transmitted through different axles. The lever will demonstrate it.

3D scheme with instructions on how to connect the L298N driver to the batteries and to the motor. Just that. Connecting to the Raspberry Pi is at a later stage of the course. 

3D scheme on how to connect the L298N Motor Driver to the Batteries. Follow the step-by-step instructions. Be careful about the PCB terminal connectors.

Step by step guide on how to add the SD card to the Raspberry pi. 

The Raspberry Pi must not be powered.  

These are 3D building instructions on how to connect a diode directly to the batteries and turn it on. 

In Robopartans classes we needed a few parts the the robot could lift in a competition. These is a box that is suitable for this

Shows the pipe attachment constructions that is mounted on the robot. The pipe is than mounted on this constuctions

These are 3D Building Instructions for an Alternative M12 Feed the Whale mission model for the FIRST LEGO League 2024-2025 SUBMERGED competition. For the original mission model, see M12 Feed the Whale.